ATEN Technology KH1516Ai User Manual download pdf (Page 195)

Appendix

183

Administrator Login Failure

If you are unable to perform an Administrator login (because the Username and

Password information has become corrupted, or you have forgotten it, for

example), there is a procedure you can use to clear the login information.

Note: Performing this procedure also returns all settings to their defaults.

To clear the login information (and return all settings to their defaults), do the

following:

1. Power off the KH1508

Ai / KH1516Ai and remove its housing.

2. Using a jumper cap, short the jumper on the IP module (the daughter card

located at the rear-left of the unit, above the mainboard), labeled J15.

3. Power on the switch.

4. Wait a few seconds. When the front panel LEDs flash, power off the

switch.

5. Remove the jumper cap from J15.

6. Close the housing and power on the KH1508

Ai / KH1516Ai.

After powering on the unit, you can use the default Username and

Password (see OSD Overview, page 25), to log in.

J15

1 2 ... 190 191 192 193 194 195 196 197 198 199 200

No comments

ATEN Technology KH1516Ai User Manual Page 195